Advertisement
Analog I/O
Analog Audio Input:
A/D Conversion:
Connectors:
Analog Audio Output: Configuration: Left/Right Discrete Stereo. Electronically balanced,
D/A Conversion:
Connectors:
Digital I/O
Digital Audio Input:
Connector:
Digital Audio Output: Stereo per AES3 standard. Output can be configured in software for flat
Connector:
76 kHz Suppression: > 80 dB (referenced to 100% modulation).
57 kHz (RDS/RBDS) Protection: better than -50 dB.
Connectors: Two EMI suppressed female BNC, floating over chassis
ground.
Maximum Load Capacitance: 5nF (at 10 ohms source impedance).
Maximum cable length: 100 feet/30 meters RG-58A/U.
Configuration: Left/Right Discrete Stereo. Electronically balanced, floating and
symmetrical.
Input impedance: 10k ohms resistive, electronically balanced.
Maximum Input Level: +24 dBu.
Nominal Input Level: +4 dBu when the Input Level Control is set to 0.0 dB.
Crystal Semiconductor CS5360, 24 bit 128x over-sampled delta sigma
converter with linear-phase anti-aliasing filter. Pre-ADC anti-alias filter,
with high-pass filter at <10 Hz.
Two EMI-suppressed XLR female. Pin 1 chassis ground, and Pin 2 is "hot".
Source Impedance: 20 ohms, electronically balanced and floating.
Load Impedance: 600 ohms or greater, balanced or unbalanced.
Output Level (100% peak modulation): Adjustable from -2 dBu to +22
dBu peak, into 600 ohms or greater load, software-adjustable.
Crystal Semiconductor CS4390 24 bit, 128x over-sampled.
Two, EMI-suppressed XLR-male. Pin 1 chassis ground, Pin 2 "Hot".
Configuration: Stereo per AES/EBU standard, CS8420 Digital Audio
Transceiver with 24 bit resolution, software selection of stereo, mono
from left, mono from right or mono from sum. Automatically accepts
and locks to input sample rates between 12 and 50 kHz.
XLR-female, EMI-suppressed. Pin 1 chassis ground, pins 2 and 3
transformer isolated, balanced, and floating – AES3 standard 110 ohm
impedance.
or pre-emphasized response at 50 or 75 microseconds.
Output sample rate fixed at 48 kHz.
XLR-male, EMI-suppressed. Pin 1 chassis ground, pins 2
and 3 transformer isolated, balanced, and floating. Standard AES3
specified 110 ohm source impedance.
Digital Output Level: -22.0 to 0.0 dBFS software adjustable.
8
Advertisement
