Rear Panel Connections; Analog Audio Inputs And Outputs; A Note About Relative Phase - Omnia .11 Installation And Operation Manual

Rear Panel Connections

Analog Audio Inputs and Outputs

Balanced XLR-type connectors are provided in the lower left section of the rear panel for the analog audio. Both
analog and digital input sources may be connected simultaneously, however, only the input source that has been
selected in the Input menu will be active. Analog/Digital/Livewire input source selection is done through the "Input
Source" software parameter setting in the Input menu.
All outputs are active simultaneously.
The stereo analog inputs
are designed for standard
+4dBu balanced signals.
Pin 2 is Hot.

A Note about Relative Phase:

If the relative phase of your installation (including the Omnia.11) differs from that of your existing system, your
announcers may feel that they sound "weird" in their headphones. If this occurs, then the relative phase of the
processor is 180 degrees from what your air talent is used to. To remedy this, you can either reverse the polarity of
both of the analog inputs or simply change the "Invert Polarity" setting to [Both] in the Input menu.
Individual Left and Right
analog outputs are available
on two male XLR jacks.
Pin 2 is Hot.
3