Advertisement
Note: If you have created Trigger Scripts and c
rememb
er your scripts until you power it off
Onc
e t e scripts are downloaded into the
h
occurs on their assigned trigger input
connected for the tri
gger scripts to execute.
Note:
When a trigger script is actually executed, any problems t
will not be noted to the user.
Script Command
Definitions
The scripting commands available for use with the Daypart Scheduler are listed in bold lettering (e.g., parts).
Their definitions (e.g., Displays the current daypart table) and usage examples are also listed. The commands
have been divided by general
in and then the enter or return key is pressed. If the command is executable (e.g., parts), then the command is
run (e.g., a table of the dayparts is displayed), otherwise the cursor simply moves to the next entry line.
Dayparts
parts
partadd <day> <time>
The "day" parameter can be assigned the fol
The "time" parameter must be defined using the following format: <hour>:<min>:<sec><am | pm> . As an
example, typing Partadd Mon 5:00:00am <enter> commands the Omnia-3 to add a daypart on Monday at
5:00:00am.
partremove
Example: partremove Mon 5:00:00am <enter>
partload
partsave
Presets
Note: After a preset is saved to the system, the Omnia knows them by their Index Number, not by their Preset
Name. Therefore, when selecting a preset, you use its index number. When saving presets, you use its name!
presets
preset <preset index #> Selects the preset by index # from the list of available presets
Example: preset 21 <enter> commands the Omnia-3 to load preset number 21 in the index list.
delete <preset index #> Deletes a preset from the preset index list by its index number.
Example: delete 21 <enter> commands the Omnia-3 to remove preset number 21 from the index list.
rename <preset index #><name> Renames the preset by its index number.
Example: rename 21 BOOGY <enter> commands the Omnia-3 to rename preset number 2.
save
Note: Factory presets are permanent and cannot be written over. You must use the 'saveas' command when
saving changes made to a factory
saveas
licked "Apply" but not "Save to Card", the Omnia will only
.
processor, they are executed when the appropriate logic transition
. Neither the Remote Control appl
functions (Dayparts, Presets, System parameters, etc.). In use, a command is typed
Displays th
e current daypart table
Adds a daypart to the daypart table.
lowing days: Sun, Mon, Tue, Wed, Thu, Fri, Sat, M-F, S-S, All.
Removes a da
ypart from the current daypart list.
Loads a daypart from the PC Card.
Saves the current daypart to the PC Card.
Lists all the currently available factory and user presets by index #.
Saves the preset under its current name.
preset in order to save it as a unique name.
Saves the preset under a different name.
ication nor the Script Editor needs to be
hat may be encountered in the execution of it
85
Advertisement
