Rack Mounting; Audio Connections - Omnia Volt Quick Start Installation Manual

Fm version

Hide thumbs Also See for Volt:

InItIAL SEt UP & AUDIO COnnECtIOnS

rACK MOUntIng

1. Install the VOLT in your equipment rack using the 4 supplied screws. If only two screws are used

for installation, they MUST be installed in the bottom holes (A) of the rack ears. As a best practice,

leave a blank space above and below the unit for proper ventilation and cooling.

1. Determine the inputs and outputs that are appropriate for your installation.

AUDIO INPUT - Both analog and digital input sources may be connected simultaneously,

however, only the input source that has been selected in the Input menu will be active.

a. For balanced line-level analog audio, connect XLR audio cables to the ANALOG LEFT IN and RIGHT IN

jacks (B).

b. For AES digital audio, connect the dual female XLR "Studio Hub" adaptor cable provided to the

RJ-45 AES IN/SYNC jack (C).

c. For an existing Axia or Livewire system, connect an Ethernet cable from the Livewire network to the

Livewire jack (D).

Table of Contents