Printer Functions; How To Print The Last Stored Measurement (Single Data Print) - Microlife BP 3BU1-5 Instruction Manual

In order to delete all stored readings,
depress the MEMORY button for at
least 7 seconds, the display will show
the symbol " CL" and 3 short beep
sounds will be heard to indicate dele-
tion of stored readings.
Note:
If your last stored measure-
ment was taken in the Average
Mode, you will see the „MAM"
symbol in approximately
3 seconds during the deletion
procedure. (The display will
show these symbols during
deletion of all stored measure-
ments if the last measurement
is taken from the Average Mode)
6. Printer Funtions
This unit can be used in connection with the Microlife diagnostic
printer. The unit can print out measurements stored in the memory by
pressing the PRINTER button. There are 2 kinds of formats available.
Please make sure you set the unit to User 1 or User 2 based on the
data you want to print.
6.1. How to print the last stored measurement.
(Single data print)
a) Select correct printer objective first before you depress the
PRINTER button.
23