Removing A Floppy Drive - Dell Precision Workstation 370 User's & Service Manual

b. Slightly press the right-side insert release tab and gently push in the insert.
If you are adding a floppy drive and you purchased the drive from Dell, you received a front panel insert in your floppy drive
kit. Attach this insert over the front of the drive bay.
If you adding a floppy that was not purchased from Dell, reattach the empty insert frame over the front of the drive bay.
Floppy Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
opening the cover.
NOTE: If you are adding a floppy drive, see

Removing a Floppy Drive

1. Follow the procedures in
2. Disconnect the power and floppy-drive cables from the back of the floppy drive.
3. Disconnect the other end of the floppy-drive cable from the system board (labeled DSKT).
1 power cable
2 floppy-drive cable
3 floppy-drive connector (DSKT)
"Installing a Floppy
"Before You Begin."
Drive."