Dell Precision Workstation 370 User's & Service Manual page 101

See "Memory Problems."
Attachment failed to respond —
Bad command or file name —
place, and used the correct path name.
Bad error-correction code (ECC) on disk read —
Controller has failed —
Data error — See "Drive
Decreasing available memory —
See "Lockups and Software
Diskette drive 0 seek failure —
Diskette read failure —
See "Drive Problems."
Diskette subsystem reset failed —
Diskette write protected —
Drive not ready — Put a floppy disk in the drive.
Gate A20 failure —
See "Lockups and Software
Hard-disk configuration error —
Hard-disk controller failure —
Hard-disk drive failure —
Hard-disk drive failure —
See "Drive Problems."
Insert bootable media Insert a bootable floppy disk or CD.
Invalid configuration information - please run SETUP program —
computer configuration information.
Keyboard failure — See
Memory address line failure at address, read value expecting value —
Problems."
Memory allocation error —
1. Turn off the computer, wait 30 seconds, and then restart the computer.
2. Try to run the program again.
3. If the error message appears again, see the software documentation for additional troubleshooting
suggestions.
Memory data line failure at address, read value expecting value —
Memory double word logic failure at address, read value expecting value —
Memory odd/even logic failure at address, read value expecting value —
See "Drive Problems."
Ensure that you spelled the command correctly, put spaces in the proper
See "Drive Problems."
Problems."
Problems."
See "Drive Problems."
Run the Dell
Slide the write-protect notch to the open position.
Problems."
"Keyboard Problems."
See "Drive Problems."
Diagnostics.
Enter system setup and correct the
See "Lockups and Software