Changing The Rear Turn Indicator Bulbs - APRILIA SR 50 Use And Maintenance Book

APRum_SR50ie##ED04_##US.book Page 73 Friday, February 18, 2005 5:32 PM
6 5
Upon reassembly:
NOTE
Make sure that the cover (2)
locates correctly into its seat on refitting.
CAUTION
Carefully tighten the screw (1) and the
screws (3), do not overtighten to avoid
d a m a g i n g t h e c o v e r ( 2 ) a n d t h e
complete turn indicator unit (4).
CHANGING THE REAR TURN
INDICATOR BULBS
Read page 71 (BULBS).
◆
Place the vehicle on the center stand,
see page 55 (PLACING THE VEHICLE
ON THE STAND).
NOTE
Before changing a bulb, check
the fuses, see page 70 (CHANGING THE
FUSES).
◆
Unscrew and remove the screw (1).
2
1
NOTE
While removing the screen, pay
attention to avoid damaging the clutch dog.
◆
Remove the shield (2).
◆
Press the bulb (3) slightly and rotate it
counter-clockwise.
◆
Extract the bulb (3) from its seat.
NOTE
Insert the bulb into the bulb
holder, so that the two pins slide into the
slots in the holder.
◆
Fit a new bulb of equal rating.
use and maintenance SR 50
2 4
73