Rear Light; Changing The Rear Light Bulb; Changing Rear Direction Indicator; Lamp Bulbs - APRILIA Scarabeo 50 I.E.-50 4T Workshop Manual

Hide thumbs Also See for Scarabeo 50 I.E.-50 4T:
Table of Contents

Advertisement

REAR LIGHT

CHANGING THE REAR LIGHT BULB

Carefully read p. 38 (BULBS).
♦ Position the vehicle on the stand.
♦ Unscrew and remove the two screws (1).
NOTE
Take great care when removing the protective
cover, so that you do not break the coupling tooth.
♦ Remove the protective cover (2)
♦ Press the bulb moderately and turn it in an anti-
clockwise direction.
♦ Remove the bulb from its holder.
NOTE
When inserting the bulb in the holder, make sure
that the two guide pins coincide with the respective slots
on the holder.
♦ Install a bulb of the same type in the correct manner.
NOTE
When reassembling, make sure the protective
cover is correctly positioned in its housing.
Tighten the screws (6) carefully and without using undue
force, to prevent damage to the protective cover.
CHANGING REAR DIRECTION INDICATOR BULBS
Carefully read p. 38 (BULBS).
♦ Position the vehicle on the stand.
♦ Unscrew and remove the two screws (1).
NOTE
Take great care when removing the protective
cover, so that you do not break the coupling tooth.
♦ Remove the protective cover (2).
NOTE
When reassembling, make sure the protective
cover is correctly positioned in its housing.
♦ Remove the protective cover (3), opening it towards
the oautside of the vehicle.
♦ Press the amber element (4) moderately, turn it in an
anti-clockwise direction and extract it.
NOTE
Take great care when removing the protective
cover, so that you do not break the coupling tooth.
♦ Press the bulb (5) moderately and turn it in an anti-
clockwise direction.
♦ Extract the bulb (5) from its housing.
NOTE
When inserting the bulb in the holder, make sure
that the two guide pins coincide with the respective slots
on the holder.
♦ Install a bulb of the same type in the correct manner.
NOTE
If the bulb holder (6) comes out of its housing,
replace it properly so that the flared opening on the bulb
holder coincides with the screw housing.

REMOVING THE REAR LIGHT

CAUTION
Handle with care.
Do not force the electric cables.
♦ Remove the 4 screws (7) shown in the figure.
♦ Take the light unit, complete with cabling, out from the
opposite side.
42
Release 00
2003-02
Scarabeo 50 I.E.-50/100 4T
1
2
6
4
5
7
1
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Scarabeo 50 i.e.-100 4t

Table of Contents