Bulbs; Changing The Dashboard Bulbs And The Clock Battery; Changing The Front Direction Indicator Bulbs - APRILIA LEONARDO 125 Use And Maintenance Book

BULBS

Carefully read p. 39 (MAINTENANCE).
!
WARNING
Risk of fire.
K e e p f u e l a n d o t h e r f l a m m a b l e
substances away from the electrical
components.
!
CAUTION
Before changing a bulb, move the
ignition switch to position "
a few minutes, so that the bulb cools
down.
Change the bulb wearing clean gloves
or using a clean and dry cloth.
Do not leave fingerprints on the bulb,
since these may cause its overheating
and consequent breakage.
If you touch the bulb with bare hands,
remove any fingerprint with alcohol, in
order to avoid any damage.
DO NOT FORCE THE ELECTRIC
CABLES.
NOTE
Before changing a bulb, check the
f u s e s , s e e p . 6 0 ( C H A N G I N G T H E
FUSES).
use and maintenance Leonardo 125 - 150 - 250 - 300
62
CHANGING THE DASHBOARD
BULBS AND THE CLOCK BATTERY
If you need assistance or technical advice,
consult your aprilia Official Dealer, who
can ensure you prompt and accurate
servicing.
CHANGING THE FRONT
DIRECTION INDICATOR BULBS
Carefully read beside (BULBS).
& " and wait
To change the bulbs:
NOTE
The following information refers to
one direction indicator only, but is valid for
both.
◆
Unscrew and remove the screw (1).
Proceed with care.
Do not damage the tangs and/or their
seats.
◆
Remove the protection screen (2).
◆
Unscrew and remove the screw (3).
A focal lens is positioned in the inner
part of the coloured screen; take care
not to invert the right and left screen.
◆
Remove the coloured screen (4).
◆
Press the bulb (5) slightly and rotate it
anticlockwise.
!
CAUTION
!
CAUTION
◆
Extract the bulb from its seat.
NOTE
Insert the bulb in the bulb socket,
making the two bulb pins coincide with the
relevant guides on the socket.
◆
Correctly install a new bulb of the same
type.
For the reassembly:
NOTE
Upon reassembly, correctly
position the protection screen (2) in its
seat.
Do not invert the position of the screws (1)
and (3).
!
CAUTION
Tighten the screw (1) and the screw (3)
moderately and with great care, in order
to avoid damaging the protection
screen (2) and the coloured screen (4).