Brake Fluid - Mercedes-Benz Sprinter Operator's Manual

Engine compartment
256
Adding coolant
If the coolant drops under the minimum
X
mark on coolant expansion tank ;, add
coolant to the maximum mark.
Observe the information on coolant mix-
ture ratio and water quality in the "Techni-
cal data" section (
damage to the engine cooling system, use
only approved corrosion inhibitor/anti-
freeze that comply with the Mercedes-Benz
Specifications for Service Products.
Replace cap : and turn it clockwise to
X
tighten.
Start the engine.
X
After approximately 5 minutes, switch off
X
the engine and allow it to cool down.
Check the coolant level again and add cool-
X
ant if necessary.
Close the hood.
X

Brake fluid

G WARNING
Service products may be poisonous and haz-
ardous to health. There is a risk of injury.
Comply with instructions on the use, storage
and disposal of service products on the labels
of the respective original containers. Always
store service products sealed in their original
containers. Always keep service products out
of the reach of children.
Brake fluid is hazardous to health. Also
observe the safety notes in the "Service prod-
ucts and capacities" section (
G
WARNING
The brake fluid constantly absorbs moisture
from the air. This lowers the boiling point of
the brake fluid. If the boiling point of the brake
fluid is too low, vapor pockets may form in the
brake system when the brakes are applied
hard. This would impair braking efficiency.
There is a risk of an accident.
page 329). To prevent
Y
page 320).
Y
You should have the brake fluid renewed at
the specified intervals.
! Brake fluid corrodes paint, plastic and
rubber. If paint, plastic or rubber has come
into contact with brake fluid, rinse with
water immediately.
Have the brake fluid renewed every 2 years
at a qualified specialist workshop. Observe
the information on brake fluid in the "Techni-
cal data" section ( page 328).
Y
Check the brake fluid level regularly, e.g.
weekly or when refueling.
Checking the brake fluid level
Stop your vehicle as far away from traffic
X
as possible on level ground.
Switch off the engine.
X
Secure the vehicle to prevent it from rolling
X
away.
Open the hood ( page 250).
X
Y
Check the brake fluid level.
X
The brake fluid level is correct if the level is
between the MIN mark and MAX mark on
brake fluid reservoir :.
Close the hood.
X
! If the brake fluid level in the brake fluid
reservoir has fallen to the MIN mark or
below, check the brake system immedi-
ately for leaks. Also check the thickness of
the brake linings. Visit a qualified specialist
workshop immediately.
Do not add brake fluid. This does not cor-
rect the malfunction.