Mercedes-Benz Sprinter Operator's Manual page 312

Changing wheels
310
! Only use the jack pump lever middle rod
and the rod with the largest diameter as a
lug wrench extension. Only slide the middle
rod as far as it will go onto the lug wrench.
The rods may otherwise bend and be dis-
torted to such an extent that they can no
longer be used as a pump lever for the jack.
! Do not place the jack on the leaf spring or
the differential case.
Hydraulic jack
Preparing the hydraulic jack
Insert the third rod of jack pump lever :
X
into the lug wrench extension.
Jack pump lever : is assembled.
Close pressure release screw ;.
X
To do this, use the flattened section on
X
pump lever : to turn pressure release
screw ; clockwise to the stop.
i
Do not turn pressure release screw ;
more than 1 or 2 full turns. Hydraulic fluid
could otherwise escape.
Insert pump lever : into the recess on the
X
jack and secure by turning it clockwise.
Place the jack vertically beneath the jack-
X
ing points described below.
Jacking point, front axle
Jacking point at the front axle
Place the jack under the longitudinal mem-
X
ber in front of the front axle.
Jacking point, rear axle (example: vehicle type
2500)
Jacking point, rear axle (example: vehicle type
3500)
Jacking point at the rear axle on vehicle
types 2500 and 3500
Place the jack under the longitudinal mem-
X
ber in front of the rear axle.