Removing The Headlight Mask With The Headlight - KTM Freeride 350 EU Owner's Manual

15 ELECTRICAL SYSTEM
15.6

Removing the headlight mask with the headlight

Main work
–
Pull the EFI control unit
–
Open fuse box cover
602809-10
–
Remove the defective fuse.
Guideline
Fuse 1 - 10 A - EFI control unit, lambda sensor, injection valve
Fuse 2 - 10 A - fuel pump
Fuse 3 - 10 A - high beam, low beam, parking light, tail light, license plate lamp
Fuse 4 - 10 A - horn, brake light, turn signal, radiator fan, speedometer
Fuses res - 10 A - spare fuses
602810-10
Info
A defective fuse is indicated by a burned-out fuse wire
Warning
Fire hazard The electrical system can be overloaded if the wrong fuses are
used.
–
–
Use spare fuses with the correct rating only.
Fuse (75011088010) (
Tip
Replace the spare fuse in the fuse box so that it is available if needed.
–
Check that the power consumer is functioning properly.
–
Close the fuse box cover.
–
Position the EFI control unit.
Finishing work
–
Lock the seat. (
–
Switch off all power consumers.
–
Detach the brake line and wiring harness
–
Release rubber band
602811-10
from the holder and hang it to one side.
1
.
2
Use only fuses with the prescribed amperage. Never by-pass or repair
fuses.
p. 100)
p. 45)
. Slide the headlight mask up and swing it forward.
2
.
A
.
1
77