Adjust Stall Force Setting; Set Auto-Close Time - GTO E-Z GATE Installation Manual

Step 6
Press the remote again to allow the
gates to fully close to verify that the
closed position is set correctly.
Repeat steps 2 - 5 if necessary

Adjust Stall Force Setting

The Stall Force potentiometer controls the amount of force the opener
will apply against an obstruction before it stops and reverses direction
within two seconds.
IMPORTANT: The Stall Force setting will need to be adjusted to
compensate for the weight and size of your gates. For safety reasons,
use the lowest possible setting to operate the gate.
The Stall Force potentiometer on the control board operates like a
volume control on a radio. Use a small flat blade screwdriver to turn the
arrow in the center of the potentiometer. Adjust the sensitivity from the
MINIMUM position just to the point where the gates operate smoothly
without obstructing from their own weight or wind conditions.
NOTE: You may need to increase the stall force in cold weather due to
increased resistance from gate hinges.

Set Auto-Close Time

The Auto-Close determines how long the gate will remain open
before it automatically closes. The factory setting is OFF. Use a small
flat blade screwdriver to adjust the settings to OFF, or from 3 to 120
seconds.
NOTE: Auto-Close timer is disabled (gate will not automatically close)
if gate is not at the fully open position.
Re-attach the cover of the control box at this time.
rev 06.13.12
Control
Box
.
1st
Gate
Opener
Gates in Closed
Position
1st OPR.
OPEN < JOG > CLOSE
2nd OPR.
MIN
STALL FORCE
SET
PWR.
LIMIT
REMOVE JUMPER FOR
PUSH TO OPEN OPTION
MIN
MAX
SFTY.
STALL FORCE
EXIT
CYCLE
EDGE
SENSOR
COMMON
LOCK+
LOCK–
WHT
GRN
RED
BLK
WHT
GRN
1st OPR.
RED
OPEN < JOG > CLOSE
BLK
2nd OPR.
MIN
14 VAC
OR STALL FORCE
SET
SOLAR
PWR.
LIMIT
REMOVE JUMPER FOR
PUSH TO OPEN OPTION
ON OFF
120
OFF
SEC.
SFTY.
AUTO CLOSE
EXIT
CYCLE
EDGE
SENSOR
COMMON
LOCK+
LOCK–
WHT
GRN
RED
BLK
WHT
GRN
RED
BLK
14 VAC
OR
SOLAR
ON OFF
Control Box Cover
2nd
Gate
Opener
STATUS
120
MAX OFF
SEC.
AUTO CLOSE
JP1
VAR1
VAR2
VAR3
VAR4
VAR5
PF1
K1
K2
BATT +
BATT –
K3
STATUS
K4
MAX OFF 120
SEC.
AUTO CLOSE
VAR6
JP1
VAR1
VAR2
VAR3
VAR4
VAR5
PF1
K1
K2
BATT +
BATT –
K3
K4
VAR6
17