Table of Contents
Advertisement
10.5 Selecting The Filtration/Heating Mode
Press and hold both control panel WARMER (
COOLER (
Then press either WARMER (
select filtration/heating mode F1-F6 or lock modes L1-L2 on the follow-
ing pages.
10.6 Filtration Modes for Spas Without Circulation Pump Option
If your spa is equipped with the circulation pump option, disregard this
section and refer to page 29 for filter cycle programming details.
Standard Filtration/Heating Modes (F1-F3)
F1 4 hours of filtration/heating per day (one 2-hour cycle every
12 hours).
F2 6 hours of filtration/heating per day (one 2-hour cycle every
8 hours).
F3 8 hours of filtration/heating per day (one 2-hour cycle every
6 hours).
Economy Filtration/Heating Modes (F4-F6)
F4 4 hours of filtration/heating per day (one 2-hour cycle every
12 hours).
F5 6 hours of filtration/heating per day (one 2-hour cycle every
8 hours).
F6 8 hours of filtration/heating per day (one 2-hour cycle every
6 hours).
Lock Modes (L1-L2)
L1 Lock Out (disables all spa functions to permit filter clean-
ing).
L2 Lock Mode (disables the jets and light buttons to prevent
unauthorized use of spa). Filtration/heating cycle will
continue to operate as programmed in this mode. The
temperature display flashes when this function is enable.
Example: the "F3" filtration/heating cycle was enabled prior to choos-
ing lock mode. The spa continues to perform the "F3" cycle until lock
mode is canceled, allowing another cycle to be selected.
Filter Cycle Setup Example
To set a time for the first filtration/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. EXAMPLE: If you desire
your first filtration/heating cycle to begin at 10:00 AM turn off power to
the spa and turn it back on again at 9:58 AM. Note: Start time is approxi-
mate and may vary slightly from day to day.
Page 28
) buttons at the same time, then release.
) and
) or COOLER (
) button to
Hide quick links:
Advertisement
Table of Contents
