Selecting The Filtration/Heating Mode - Sundance Spas Camdenl Certa Owner's Manual

10.4

Selecting The Filtration/Heating Mode

Press and hold both control panel WARMER (
( ) buttons at the same time, then release. Then press either
WARMER (
mode F0-F6 or lock modes L1-L2 outlined below.
Standard Filtration/Heating Modes
F0 5 minutes of filtration per day (one 5 minute "blow-out"
cycle every 24 hours to purge all plumbing lines)
F1 1 hour of filtration per day (one 30-minute cycle every 12
hours); this is the factory default setting.
F2 1.5 hours of filtration per day (one 30-minute cycle every
8 hours)
F3 2 hours of filtration per day (one 30-minute cycle every 6
hours)
Economy Filtration/Heating Modes
F4 1 hour of filtration/heating per day (one 30-minute cycle
every twelve hours)
F5 1.5 hours of filtration/heating per day (one 30-minute
cycle every eight hours)
F6 2 hours of filtration/heating per day (one 30-minute cycle
every six hours)
Lock Modes
L1 Lock Out (disables all spa functions to permit filter
cleaning)
L2 Lock Mode (disables the jets and light buttons to prevent
unauthorized use of spa.) Filtration/heating cycle will
continue to operate as programmed in this mode. The
temperature display flashes when this function is enabled. Example:
the "F3" filtration/heating cycle was enabled prior to choosing lock
mode. The spa continues to perform the "F3" cycle until lock mode
is canceled, allowing another cycle to be selected.
To set a time for the first filtration/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. EXAMPLE: If you desire
your first filtration/heating cycle to begin at 10:00 AM turn off power to
the spa and turn it back on again at 9:58 AM. Note: Start time is approxi-
mate and may vary slightly from day to day.
Page 28
) or COOLER ( ) button to select filtration/heating
) and COOLER