Trim Strip; Step 12, Adjust Door Swing - GE ZICP720 Design Manual With Installation Instructions

11 INSTALL CENTER TRIM STRIP
• Open doors fully.
• The case trims should be evenly aligned top to
bottom with a slight gap between them.
• Starting at the top, press center trim strip (D) over the
inside case trims of both refrigerators.
• Continue pressing trim until you reach the bottom of
the case trims. The trim should align with the top and
bottom of case trims.
12 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 130°, you may change the door swing to
a 90° opening. Skip this step if door opening is
satisfactory for your installation situation.
• Lift the grille panel to access the door stop.
• Use pliers to unscrew door stop and reinstall
into the 90° position.
Installation Instructions
13
Case Trim
U-Shape
Trim
Pin Location
For 90°
Door Swing
Pin Location
as Shipped
For 130°
Door Swing