Connecting The Satellite (Front, Center, Surround) Speakers - JVC TH-S55 Instructions Manual

Connections
Do not connect the power cord until all other connections have been made.
Connecting the satellite (front, center, surround)
speakers
Before connecting the
speaker cords;
Twist and pull the insulation coat
off and remove.
Powered subwoofer
SP-PWS66
Front speakers
SP-THS66F
CAUTION
• When you connect speakers other than the supplied ones, use
speakers of the same speaker impedance (SPEAKER IMPEDANCE)
indicated near the speaker terminals on the rear of the powered
subwoofer.
• DO NOT connect more than one speaker to one speaker terminal.
• Connect the black cords to the black (r) terminals.
• Connect the white cords to the (q) terminals referring to the table below:
FROM
XV-THC3
XV-THS55
XV-THS58
XV-THS66
4Ω 16Ω
4 m
Speaker cord (supplied)
FRONT SPEAKERS (LEFT)
FRONT SPEAKERS (RIGHT)
CENTER SPEAKER
SURROUND SPEAKERS (LEFT)
SURROUND SPEAKERS (RIGHT)
Center speaker
SP-THS66C
10 m
Precautions for daily use
• When moving the speakers, do not pull the speaker cords;
otherwise, the speakers may fall over, causing damage or injury.
• When holding a speaker, always grasp the lower portion.
• Do not lean against the speakers, as the speakers could fall down
or break, possibly causing an injury. Especially be careful that
children do not lean against them.
• Do not reproduce sounds at so high a volume that they are
distorted; otherwise, the speakers may be damaged by internal
heat buildup.
This page is for
White
Red
Green
Blue
Gray
White
4 m
Black
Black
Surround speakers
SP-THS66S
TH-S66
Red
10