Table of Contents
Advertisement
through the three repeat modes:
.
REPEAT
The appropriate indicator (
) lights in the display when a repeat
REPEAT 1
mode is active.
Using the main unit menu system
1
Press the appropriate
the
until the display shows
MULTI DIAL
. Push the
MULTI DIAL
MENU
Continuous playback
When this is enabled (the
lit), when playback ends on the drive currently play-
ing back (either because the end of the disc or the end
of programmed playback is reached), playback auto-
matically starts on the other drive, if a playable disc
is inserted in it.
If the playback order changes to a drive without a
playable disc loaded, the playback stops when the
lack of a disc is discovered by the CD-RW402.
NOTE
If a repeat mode is selected ("Repeat playback" on
page 24), the repeat potion will keep repeating, and
playback will not be transferred to the other drive
while repeat is active.
Pitch control (drive 1 only)
The pitch (and speed) of the playback can be altered
between –9.9% and +9.9%.
This allows "stretching" or "compressing" of mate-
rial to fit available slots.
Turning pitch control on and off
Use the
key on the main unit or the remote
PITCH
control unit to turn the function on or off. The indica-
tor lights when pitch control is enabled (even if the
pitch value is set to 0.0%).
Setting the pitch value (i)
To set the pitch control from the main unit:
1
Press the appropriate
the
MULTI DIAL
until the display shows
. Push the
MULTI DIAL
MENU
4 – Playback operations—Continuous playback
,
or
ALL
1
or
REPEAT ALL
MENU
key and turn
PLAY
.
indicator is
CONT PLAY
key and turn
MENU
PLAY
.
2
Turn the
MULTI DIAL
. Push the
REPEAT MODE?
3
Turn the
MULTI DIAL
shows
,
REPEAT> OFF?
REPEAT> ALL?
Push the
MULTI DIAL
The appropriate indicator (
) lights in the display when a repeat
REPEAT 1
mode is active.
When a drive is not playing back, the tray may be
opened, and the disc may be replaced with another
disc, allowing continuous playback of varied pro-
gram material. The order of tracks to be played back
may be programmed on the "idle" drive, and on drive
1 the TOC may be edited, etc.
Use the transport keys and control on the active drive
to control playback.
Press the
key to turn off the indicator to
CONT PLAY
cancel this function.
The
analog outputs are probably most
COMMON
useful when using this function, as the output will
always be that of the drive currently playing.
NOTE
When pitch control is on, the display shows the nominal
time taken from the code on the CD, not the actual
elapsed or remaining time at the new speed. Do not use
the display for timing pitch changed-material.
2
Turn the
MULTI DIAL
. Push the
MULTI DIAL
PITCH
?
3
Turn the
MULTI DIAL
shows
, where xx is anything
PITCH> x.x%
between –9.9% and 9.9%. 0.0%, of course, is
the standard pitch. The value is set
immediately.
4
Push the
MULTI DIAL
mode.
TASCAM CD-RW402 Owner's Manual
until the display shows
.
MULTI DIAL
so that the display
or
.
REPEAT> 1 ?
.
or
REPEAT ALL
until the display shows
.
so that the display
to exit the menu setting
25
Advertisement
Table of Contents
