Table of Contents
Advertisement
Index operations
Many CDs contain index information as sub-track
divisions, often in classical music to mark scene divi-
sions in opera or the beginning of instrumental pas-
sages, etc. The CD-RW402 also supports indexes,
Index increment
Whether the index increment option is on or off (see
below), it is possible to increment the index markers
manually by pressing the drive 2
recording takes place.
However, by setting the index increment option on,
index markers outside the tracks in the SUB-Q code
of SPDIF digital signals will be automatically
recorded. Index numbers are shown in small digits to
the right of the track number.
1
Press the
key (2) and turn the
MENU
DIAL
to display
REC MENU 2 ?
Setting the length of index 00
Index 00 is typically used as a lead-in track. The
default length is 1 second, but it can be set in 1-sec-
ond increments from 0 seconds to 4 seconds:
1
Press the
key (2) and turn the
MENU
to display
DIAL
REC MENU 2 ?
2
Press the
MULTI DIAL
3
Turn the
MULTI DIAL
.
INDEX00 TM?
Extended check (overburning)
On some media, it is possible to record over the
stated time as marked on the disc.
To check this:
1
Press and hold the
RECORD
(in stop mode) for more than 2 seconds.
2
The display shows
ExtendCheck?
or
MULTI DIAL
REC
to cancel the operation.
STOP
While the check is taking place, the display
shows
with a flashing
ExtendCheck
to the right for some time.
When the check is complete, the display
shows
.
COMPLETE
key as
CALL
MULTI
.
MULTI
.
.
until the display shows
key of drive 2
. Press the
key to start the check,
(asterisk)
*
5 – Recording—Index operations
and allows you to carry out a number of useful opera-
tions with regard to them.
Note that although both drives of the CD-RW402 can
display index markers, there is no index locate facil-
ity built into the CD-RW402.
2
Press the
MULTI DIAL
3
Turn the
MULTI DIAL
.
INDEX INC ?
4
Press the
MULTI DIAL
5
Turn the
MULTI DIAL
setting between
IndexInc>
6
Press the
MULTI DIAL
leave the menu.
4
Press the
MULTI DIAL
5
Turn the
MULTI DIAL
setting between 0s and 4s in 1-second
INDEX00>
increments.
6
Press the
MULTI DIAL
leave the menu.
The check can be interrupted by pressing the
Drive 2
STOP
key. No other key is enabled
while the check is taking place.
After the check is complete, the available
time for recording may be extended, as
shown on the display.
NOTE
Although the CD-RW402 may report that extended
recording may take place on a disc, it may be that
extended recording is not actually possible when it is
attempted.
Because such extended recording does not conform to
the Orange Book standard, discs created in this way
may not be playable on other CD players.
TASCAM CD-RW402 Owner's Manual
.
until the display shows
.
to change the fade time
and
.
ON
OFF
to make the setting and
.
to change the fade time
to make the setting and
39
Advertisement
Table of Contents
