Rear Panel Description - D-Link DGS-3000-10TC Hardware Installation Manual

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch Hardware Installation Guide

Rear Panel Description

The rear panel contains an AC power socket, an ON/OFF toggle switch, an outlet for an external redundant power
supply or a DC power supply, and security lock.
The AC power socket is a standard three-pronged connector that supports the power cord. Plug-in the female
connector of the provided power cord into this socket, and the male side of the cord into a power outlet. The Switch
automatically adjusts the power setting to any supply voltage in the range from 100 to 240 VAC at 50 to 60 Hz. An
optional external Redundant Power Supply (DPS-200) can be plugged into the RPS outlet displayed above. When the
internal power fails, this optional external RPS will take over all the power immediately and automatically.
Figure 1-7 Rear panel view of the DGS-3000-10TC
Figure 1-8 Rear panel view of the DGS-3000-24TC
Figure 1-9 Rear panel view of the DGS-3000-26TC
6