Installing The Switch Without A Rack; Attaching Brackets To A Switch For Rack Mounting - D-Link DGS-3000-10TC Hardware Installation Manual

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch Hardware Installation Guide

Installing the Switch without a Rack

First, attach the rubber feet included with the Switch if installing on a desktop or shelf. Attach these cushioning feet on
the bottom at each corner of the device. Allow enough ventilation space between the Switch and any other objects in
the vicinity.

Attaching Brackets to a Switch for Rack Mounting

The Switch can be mounted in a standard 19" rack using the provided mounting brackets. Use the following diagrams
as a guide.
Fasten the mounting brackets to the Switch using the screws provided. With the brackets attached securely, the
Switch can be mounted in a standard rack, as shown below.
NOTE: Please review the Installation Guidelines above before installing the Switch in a rack. Make
sure there is adequate space around the Switch to allow for proper air flow, ventilation, and
cooling.
Figure 2-1 Prepare the Switch for installation on a desktop or shelf
Figure 2-2 Fasten mounting brackets on the Switch
9