Dimplex Ec-eau Installation And User Instructions Manual page 18

F
G
Step 3: Fit two M5 fixing screws into the cylinder bracket (F). Slide the sensor
mounting plate behind the M5 fixing screws (G).
H
Step 4: Insert two remaining M5 screws (H). Tighten the screws until the thermostat
bulbs and heat pump sensor are held firmly against the wall of the inner cylinder.
Note: there should be no movement in the phials (four clips in the centre of the
sensor mounting plate) that are used to hold the bulbs and sensor. Care should be
taken not to overtighten the screws.
Installation