Vehicle Identification Plates; Retrofitting - Mercedes-Benz Sprinter Operator's Manual

Hide thumbs Also See for Sprinter:
Table of Contents

Advertisement

general operating permit and the insurance
cover, and lead to the loss of the New
Vehicle Limited Warranty.
Retrofitting electrical or electronic
equipment
Electrical and electronic equipment can
jeopardize the operational safety of the
vehicle. If equipment of this kind is retrofitted,
it must be type-approved and bear the e
mark. The e mark may be obtained from the
equipment manufacturer or an authorized
testing center.
! Damage or consequential damage arising
from installing equipment that is not
approved for Sprinters is not covered by
the New Vehicle Limited Warranty.
If you wish to install telephones or two-way
radios in the vehicle, you must obtain formal
approval.
For operation of mobile phones and two-way
radios, We recommend connection to an
approved exterior antenna. This is the only
way to ensure optimum reception quality
inside the vehicle and to minimize mutual
interference between the vehicle electronics,
mobile phones and two-way radios.
G
Warning
Excessive electromagnetic radiation may
constitute a health hazard to yourself and
others. Use of an exterior antenna gives
consideration to scientific discussion
surrounding the possible health risk posed by
electromagnetic fields.
The exterior antenna should only be installed
at a qualified specialist workshop which has
the necessary specialist knowledge and tools
to carry out the work required. We
recommend that you use an authorized
Sprinter Dealer for this purpose. In particular,
work relevant to safety or on safety-related
systems must be carried out at a qualified
specialist workshop.

Vehicle identification plates

The transmission output of the mobile phone
or two-way radio must not exceed the
maximum transmission outputs listed.
Frequency range
Short wave
(f < 50 MHz)
4 m waveband
2 m waveband
Trunked radio/Tetra
70 cm waveband
GSM 900/AMPS
GSM 1800
UMTS
! If electrical or electronic equipment
which does not fulfill these conditions is
used in the vehicle, the vehicle's general
operating permit may be invalidated.
Vehicle identification plates
Vehicle identification plates
The vehicle identification plate with the
vehicle identification number (VIN), the paint
code, and the specifications for the
permissible weights is located on the base of
the driver's seat.
Maximum
transmission
output (PEAK)
100 W
30 W
50 W
35 W
35 W
10 W
10 W
10 W
Z
277

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sprinter 2013Sprinter 2500Sprinter 3500

Table of Contents