Joovy Caboose Ultralight 45X Series Instruction Manual page 12

Using the Stroller as an Infant
Car Seat Carrier
• To use the stroller to carry an infant car seat
carrier, you must replace the Front Tray with
the Car Seat Carrier Support.
• Remove the Front Tray by pressing in on
the lock tabs and pulling the tray off the
brackets. Store the tray in a convenient
place for later use.
• Line up the female fittings on the Car Seat
Carrier Support to the male fittings on the
front of the stroller and push inward until the
fittings snap into place. See Figure 25. Pull
outward on both sides of the support to be
sure both are snapped securely in place.
• Push the canopy to its most rearward
position.
• ADJUST THE SEATBACK TO ITS RECLINED
POSITION.
• Remove the infant carrier from the car seat
base.
• Place the infant carrier onto the top of the
stroller in a REAR FACING POSITION,
locating the head end of the carrier so that
it rests on the Car Seat Carrier Support and
the feet end of the carrier so that it rests on
the seatback, but NOT on the top edge of
the seatback. See Figure 26.
• Ensure that the head end of the infant carrier
is pushed down firmly INSIDE the frame of
the Car Seat Carrier Support and that it is
centered side to side.
• Remove the carrier restraining straps from
the pouches on both sides of the stroller.
Buckle them in place over the LOWEST part
of the carrier sides. Adjust the straps so they
are tight around the carrier but AWAY from the child's neck. Pull up on the carrier to be sure it is
held on securely. See Figure 27.
• Always check frequently to be sure that the restraining straps are tight across the infant carrier
but away from the child's neck.
• When you remove the infant carrier from the stroller, always replace the two restraining straps
back into their side pouches.
Page 11
Figure 25
Figure 26
Figure 27
Caboose Ultralight Instruction Manual