Charging A Newly Activated Sealed Vrla Battery; Сharging Instructions For Newly Activated Sealed Vrla Batteries - Suzuki SV650/S Service Manual

Hide thumbs Also See for SV650/S:

Table of Contents

Charging a Newly Activated Sealed VRLA Battery

Sealed VRLA batteries require an initial charge. If you are

using a constant current charger, refer to the standard

(STD.) charging method printed on the battery. If you are

CHARGING INSTRUCTIONS FOR NEWLY ACTIVATED

NEVER REMOVE THE SEALING STRIP AFTER CHARGING IS COMPLETED!

If the battery gets very hot to the touch, cease charging and allow battery to cool down.

Check voltage using a voltmeter. Readings for a charged, newly-activated battery should

be 12.8v or higher after the battery is charged and sits for at least 1 - 2 hours.

Yuasa Automatic Chargers and Accessories are the safest and most convenient

method for error proof charging and battery maintenance.

SEALED VRLA BATTERIES

THIS IS A SEALED BATTERY; THE SEALING CAPS SHOULD BE CONSIDERED PERMANENT.

DO NOT REMOVE THE CAPS TO ADD WATER OR TO CHARGE THE BATTERY; CHARGE AT

12V AT THE AMPERAGE AND HOURS STATED BELOW.

These batteries are a sealed VRLA construction – which means:

If less, it needs an additional charge.

using an automatic type taper charger, check to make sure

that the charger current (amps) is equal to or greater than

the standard (STD.) charging method listed on the battery.

5~10h or QUICK:9.0A