Operation Timing - Konica Minolta bizhub c650 Service Manual

22. Image stabilization control

22.4 Operation timing

A. Image stabilization when not printing
Mode
• A new transfer belt is detected
• IU units are removed and installed.
• A new IU is detected (Image stabilization sequence is executed only for a new IU that
Mode 1
has been installed)
• Skew adjustment is reset (Service mode)
• After initialization and image stabilization (Service mode)
• The main power switch is turned ON
• The trouble codes and jam messages are reset
Mode 2 • After image stabilization control is discontinued, a door is closed.
• While a warning code is being displayed, the front door is opened and closed.
• Image stabilization (Service mode)
• The threshold of PH temperature change is detected during the standby state or dur-
Mode 4
ing a print cycle.
Mode 5 • Gradation Adjust
162
Theory of Operation Ver. 8.0 Jun. 2008
Operation condition