Table of Contents
Advertisement
6.2
Hydraulic connections
Hydraulic connection to the units must be realized with flexible pipes which do not cause
an action on the tank to avoid damaging the unit.
The hydraulic connections are positioned on the bottom side of the humidifier. Input
connection is 3/4" and output is 1/4".
The minimal pressure at the entry of the pump should be lower than 0.5 at maximum flow.
6.3
Steam Output
The steam output is positioned in the upper part of the humidifier (top cover). The outlet
has a diameter of 40mm. To avoid the release of micro-droplets of water by the output
should be installed a distribution ramp of 40 cm minimum. The ramp can be made of PVC or
other material (as required by the application). In case you can not install a ramp of 40 cm
at the exit you can install a double stitched at 90° to create a trap for micro-drops.
6.4
Electrical connections
All work concerning electrical installations WILL HAVE to be carried
out exclusively by qualified personnel (ex electricians or technicians
laying out from a suitable formation). The customer IS responsible for
the adequacy of the personnel used.
Please check that power supply is disconnected before any
maintenance and installation operation.
The person in charge of installation will have to ensure the following points :
Size of electrical cables must be appropriate for the maximum current being
provided.
The power supply cable will have to be protected using an appropriate cable gland.
Elsteam S.r.l - via E.fermi, 496 - 21042 Caronno Pertusella (va) - Tel.+39 02 9659890 - Fax +39 02 96457007
E-mail: infocomm@elsteam.com/infotech@elsteam.com - Web: http://www.elsteam.com
p.iva 01463940120 - c.f.05046150156 - trib.di busto a. 16415-c.c.i.a.a. varese 174164 - cap.soc.i.v. euro 10400,00
6
Advertisement
Table of Contents
