Nortec GS 100 Installation, User & Maintenance Manual page 63

Transducer Input
This section is used to configure the controller for transducer signals
In this section you can adjust the proportional, integral and derivative constants. There is also a PID learn
algorithm which will tune the various PID constants for optimal performance.
Capacity Limit
In this section the customer can adjust the maximum output of the humidifier between 25-100%.
To adjust the maximum capacity, highlight the selection then enter the user code (0335). Press enter. Use the
UP/DOWN arrows to adjust the output between 25 and 100%.
DATE/TIME/UNITS
LANGUAGE CONTROLS
WATER MANAGEMENT
CONTROL TYPE
CAPCITY LIMIT
CALIBRATE
Calibrate
This selection is used to fine-tune the operating range of the controller. Some modulation signals are not precisely
as stated e.g. a 0-10 controller could actually modulate over a 0-11 volt range.
This selection should only be used by factory-trained individuals.
SET MAXIMUM
CAPACITY XXX%
- 59 -
SET MAXIMUM
CAPACITY XXX%
0335