Troubleshooting - KTM 690 SMC R 2014 Owner's Manual

20

TROUBLESHOOTING

Faults
The engine does not turn when the
starter button is pressed
Engine turns only if the clutch lever is
drawn
Engine turns but does not start.
Engine has too little power.
Engine overheats.
Possible cause
Operating error
Battery is discharged
Fuse 1 or 2 blown
Main fuse burned out
No ground connection present
The vehicle is in gear
The vehicle is in gear and the side
stand is folded out
Operating error
Fuse 3 blown
Coupling of fuel hose connection not
connected
Defect in fuel injection system
Air filter is very dirty
Fuel filter is very dirty
Defect in fuel injection system
Too little coolant in cooling system
Radiator fins very dirty
Action
–
Carry out the start procedure. (
–
Recharge the battery. x
–
Change the fuses of individual power consumers.
( p. 121)
–
Set the clock. ( p. 32)
–
Change the main fuse. (
–
Check the ground connection.
–
Shift gear to neutral.
–
Shift gear to neutral.
–
Carry out the start procedure. (
–
Change the fuses of individual power consumers.
( p. 121)
–
Reconnect coupling of fuel hose connection.
–
Read out the fault memory using the KTM diag-
nostics tool. x
–
Remove the air filter.
x
–
Install the air filter. x (
–
Check the fuel pressure.
–
Read out the fault memory using the KTM diag-
nostics tool. x
–
Check the cooling system for leakage.
–
Check the coolant level. (
–
Clean radiator fins.
158
p. 47)
( p. 115)
p. 118)
p. 47)
( p. 76)
p. 77)
x
p. 134)