14
ELECTRICAL SYSTEM
14.11
Changing the turn signal bulb
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully swing turn signal glass
–
Press the turn signal bulb carefully into the socket, turn it counterclockwise by about
30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until it
100160-10
stops.
Turn signal (RY10W / socket BAU15s) (
–
Position the turn signal glass.
–
Insert the screw and turn it counterclockwise first until it engages in the thread. Tighten
the screw slightly.
Finishing work
–
Check the turn signal system function.
forward and take it off.
p. 174)
129