STORAGE DATA PROGRAM
Storage data program
For your convenience, Ultimate 200W×2 has a data storage and load program. It can
store ten batteries data representing the respective specifications of batteries. You can
call back the data when charging or discharging without setting up the program again.
Press Start/Enter key to make it blink, and use Inc or Dec to set up the parameter.
Start
Enter
Capacity Type of
Data
Voltage
number
Start
Batt type
'> 3 seconds '
Enter
stop
-
DEC INC
DEC
-
+
-
DEC
INC
DEC
DEC INC
-
-
+
DEC
INC
DEC
Start
'> 3 seconds '
Enter
· 23
Setting of the parameter in the screen will not affect the
charge and discharge process. They just present the
specification of the battery. The example is NiMH battery
pack, including 12 cells, the capacity is 3000m Ah.
battery
Set up the charge current in the manual mode, or current limit
in the auto mode. Press Inc and Dec key simultaneously to
make the current field blink to switch the charge mode.
+
INC
Set up the discharge current and final voltage.
+
INC
Set up the charge/ discharge sequence and cycle number.
+
INC
Saving the data
Ultimate 200W×2