KYMCO MXU 300 User Manual page 308

15.
REAR WHEEL/AXLE/SUSPENSION
DRIVING MECHANISM
Remove the swingarm bearing race and
bearing plate by using the special tool.
Special tool: Bearing puller
The removed bearing and dust seal must
be replaced with new ones.
Install the new swingarm bearing race and
its new plate to the swingarm by using the
special tool.
Special tool:
Oil seal & bearing installer
When installing the bearing plate, make
sure that the bulge of bearing plate faces
inside.
Apply grease to the swingarm bearing and
lips of dust seals, then install them into the
swingarm with the special tool.
Special tool:
Oil seal & bearing installer
Remove the three bolts and dust plate.
Check the dust seal for wear or damage.
Remove the O-ring.
15-39
E037
E014
E014
Dust Seal
Bearing Plate/Bearing Race
Bearing/Dust Seal
Bolts Dust Plate
MXU 300/250
Bearings
O-ring