KYMCO MXU 300 User Manual page 268

14.
FRONT WHEEL/FRONT SUSPENSION/
STEERING SYSTEM
Inspect the steering column.
Bends/damage →Replace.
Do not attempt to straighten a bent shaft,
this may dangerously weaken the shaft.
Inspect the steering brackets and oil seal.
Wear damage →Replace.
INSTALLATION
Reverse the "REMOVAL" procedures.
Apply the grease onto the collar, dust
seals, and bearing.
Install the steering column and collar, then
tighten the nut under the frame body.
Torque: 7 kgf-m (70 Nm, 50 lbf-ft)
Install the cotter pin and band ends of cotter
pin.
Always use a new cotter pin.
Assembly the steering column and tighten
the two bolts.
Torque: 2.2 kgf-m (22 Nm, 16 lbf-ft)
Install the tie rods and washer, then tighten
the nut.
Torque: 2 kgf-m (20 Nm, 15 lbf-ft)
Install the cotter pins and band ends of
cotter pins.
Always use a new cotter pin.
Refer to the "TOE-IN ADJUSTMENT"
section in the CHAPTER 3 to adjust toe-in.
14-23
MXU 300/250