Honda Magna VF750C Service Manual page 138

CAUTION
Install the oil orifice with the larger inner diameter side facing the lower crankcase.
•
If the lower crankcase installation is difficult, make sure the transmission assembly is installed correctly.
•
N OTE
Refe r to page 1 1 - 1 8 fo r cra n kcase sea l a nt a rea and deta i l of the bolt l ocati ons.
•
Requisite Service
O i l pu m p insta l lation ( page 4-3)
•
Sta rter m otor i n sta l lati on ( page 1 7-7 )
•
Alte rnator i n sta l l ation ( page 1 5- 1 0)
•
C l utch i n sta l latio n ( page 9-6)
•
Procedure
Combination Order
( 1 ) U pper cra n kcase
O i l orifice/0-ring
( 2 )
(3) Dowe l p i n
( 4) Lower cra n kcase
(5) Lowe r cra n kcase bo lt, 9 mm
Lower cra n kcase bolt, 8 mm
(6)
Lowe r cra n kcase bo lt, 6 m m/washer
( 7 )
U pper cra n kcase bo lt, 10 m m/washer
(8)
(9) Ca ble g u ide
U pper cra n kcase bo lt, 6 m m/washer
( 1 0)
( 1 1 ) M a i nshaft bea ring set plate
( 1 2 ) M a i nshaft bea ring set plate bolt
Gearshift i i n kage i n sta l lati o n ( page 1 0-4)
•
Cyl i nder head/ca mshaft i n sta l l atio n ( page 8-2 )
•
E n g i n e i n sta l latio n ( page 7-2)
•
Q ' ty
CAUTION
1
Do not apply sealant around the oil passage area and
•
main journal bearing area.
Refe r to page 1 1 - 1 8 fo r deta i l fo r the a p p l icatio n a rea.
1/1 I nsta l l it as i l l ustrate d.
3
1 A t i n sta l lati on, make s u re the shift fo rks engage properly
with the correspo n d i n g gea rs.
Tig hten i n g order ( page 1 1 - 1 9 )
7/1
1 A l i g n t h e cut out o f t h e shift fo rk shaft with t h e set plate.
3 Clean and a pply a l ocki ng agent to the bolt th reads.
Crankshaft/Piston/Transmission
Remarks
1 1 - 1 5