Configuring The Device Manager; Running The Device Manager - Avaya C360 Quick Start For Hardware Installation

Device Manager

Configuring the Device Manager

Configuring the Device Manager
You can configure several Device Manager parameters using the CLI. These parameters include
the time-out and retries parameters, the location of the Web server that provides the help files
for the Device Manager, and the Java plug-in required for running the Device Manager.
Device Manager Commands
The following Device Manager commands are available.

Running the Device Manager

NOTE:
You should assign an inband or out-of-band interface IP address to the switch
before beginning this procedure.
1
Open your browser.
2
Enter the URL of the switch in the format http://aaa.bbb.ccc.ddd where
aaa.bbb.ccc.ddd is the inband or outband interface IP address of the switch.
— The user name is "root".
— The default password for read-only access is "root".
— The default passwords for read-write access is "root".
NOTE:
The C360 Device Manager passwords are the same as those of the CLI. If you
change the passwords of the CLI then those passwords become active for the
Device Manager as well. For further information on the passwords, refer to the
Avaya C360 Installation and Configuration User Guide.
The welcome page is displayed.
24 Quick Start for Hardware Installation: Avaya C360 Converged Stackable Switch
In order to...
Set the SNMP retries parameter
Set the SNMP time-out parameter
Set the location of the Web server with
the help files and the Java plug-in
Display the SNMP retries parameter
Display the SNMP time-out parameter
Display the URL of the Web server
with the help files and the Java plug-in
Use the following command...
set snmp retries
set snmp time-out
set web aux-files-url
show snmp retries
show snmp time-out
show web aux-files-url
May 2004