Command Description - Digi TransPort WR44RR Installation Manual

To stop the DHCP server from serving addresses, use the following command:
Command
DHCP 0 IPMIN X
As an example, to stop the DHCP sever from DHCP requests, enter the command DHCP 0 IPMIN !. The !
variable is used to remove a value or set it back to its default.
To retain the DHCP server, but on a different subnet, the following parameters will need to be configured:
Command
DHCP 0 IPMIN x�x�x�x
DHCP 0 IPRANGE
DHCP 0 GATEWAY x�x�x�x
DHCP 0 MASK x�x�x�x
DHCP 0 DNS
For more information on CLI commands, visit http://www.digi.com/support/ and view the various reference
manuals available.
TransPort ® WR44RR Installation Guide
Description
Removes the minimum IP address that will be server via DHCP,
disabling the DHCP server
Description
Minimum IP address to assign, the start of the DHCP pool
The number of IP addresses in the DHCP pool
The IP gateway address the DHCP clients should use
(normally this router's LAN IP address)
The subnet mask DHCP clients should use
The DNS server DHCP clients should use
Page 17