Samsung SCU-9051 User Manual page 40

setup
CAMERA SETUP (SCU-9051/VAC/VAC1)
This setup guide is intended for SCU-9051/VAC/VAC1 that may differ depending on the camera module.
Protocol Type
This enables you to specify the protocol type of the
camera module. Improper protocol settings may
result in an abnormal operation of the product.
- SAMSUNG-T: SCB-3000/SHC-745
- SAMSUNG-E: SCB-4000
Lens Type (SCU-VAC/VAC1)
- FEEDBACK / NON F/B /SLA-12240 / SLA-880:
Select a model if using a Samsung product
(SLA-12240/SLA-880); select a model that
supports feedback if using a third-party product.
- Reversed Zoom:
Depending on the wiring direction, Tele/Wide
can be controlled reversely. This is what you can
use to make the product work properly without
changing the wiring. (OFF: Disabled, ON: Enabled)
- Zoom Tele Pos.(Feedback/SLA-12240 Lens
Specifi cation):
If the feedback value from the motorized zoom
lens increases when you perform the zoom
tele, you must set the value to Increase (Default)
so that the zoom factor will be displayed
accordingly.
However, if an abnormal zoom factor is
displayed, you must set the value to Decrease so
that the zoom factor will be displayed accordingly.
- Reversed Focus :
Depending on the wiring direction, Far/Near can be controlled reversely. This is what you can use
to make the product work properly without changing the wiring.
- Focus Near Pos.(Feedback/SLA-12240 Lens Specifi cation):
If the feedback value from the motorized zoom lens increases when you perform Focus Near, you
must set the value to Increase (Default) so that the Focus function works properly.
However, if the Focus function does not work properly, you must set it to Decrease so that it
works properly.
- Display Zoom (Feedback/SLA-12240 Lens Specifi cation):
Select this if you want to display the value of the zooming position according to the feedback from the
motorized zoom lens. (However, the displayed value is a position value rather than the zoom factor.)
setup
40_
Main Menu
► Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
Initialize
Status
Camera Setting
► Protocol Type
Comm. Setting
Open Camera Menu
<SCU-9051 >
Camera Setting
► Protocol Type
Lens Type
Open Camera Menu
<SCU-VAC/VAC1>
SAMSUNG-T
SAMSUNG-T
SLA-880