Silicon Graphics 1450 Quick Start Manual page 8

SGI 1450 Server Quick Start Guide
Determining Power Cord Requirements
!
4
Warning:
Never modify a supplied AC power cord. Do not use a supplied AC power
cord if it is not the exact type required in the region where the server will be installed
and used. Replace the cord with the correct type. Refer to the cord requirements
described below. Do not plug in the server power cord yet if you will be adding
internal parts (boards, DIMMs, removable media drives).
Caution: The power supply in this product contains no user-serviceable parts. There
may be more than one supply in this product. Obtain servicing only from qualified
personnel. The DC power on/off button on the system does not turn off system AC
power. To remove AC power from the system, you must unplug each AC power cord
from the wall outlet or power supply.
The power cords must meet these requirements:
• Rating: Cords must be rated for available AC voltage and have a current rating at
least 125% of the current rating of the server.
• Connector, wall outlet end: Cords must be terminated in a grounding-type male
plug designed for use in your region. It must have certification marks showing
certification by an agency acceptable in your region.
• Connector, server end: The connector that plugs into the AC receptacle on the
server must be an IEC 320, sheet C13, type female connector.
• Cord length and flexibility: Cords must be less than 4.5 meters (14.76 feet) long,
and must be flexible (harmonized) or VDE-certified to comply with the server's
safety certifications.
007-4275-001ML