Tool Kit; Air Intake Opening; Seat Strap; Seat Latch - Sea-doo 2001 GS Operator's Manual

22) Tool Kit

Contains tools needed to perform basic
watercraft maintenance.

23) Air Intake Opening

This is where air enters to supply the
engine and ventilate the engine com-
partment. If the air intake opening is
kept under water, water will get inside
bilge.
CAUTION: If the air intake opening
is kept under water, such as turning
constantly in tight circles, water will
get inside bilge, which may cause
severe damage to internal parts of
the engine.

24) Seat Strap

The seat strap provides a handhold to
assist boarding and is used as a hand-
hold for the passenger.

25) Seat Latch

Removing the seat allows access to
the engine compartment.
The seat latch is located at the rear end
and underneath the seat.
2-Up Seat
F01L8XZ
TYPICAL
1. Seat latch
44
1
www.SeaDooManuals.net
3-Up Seat
1
F17L0EY
1. Seat latch
All Models
To remove seat, pull the latch lever up-
ward and hold. Lift and pull the seat
rearward.
NOTE: On the 3-up seat models, it is
necessary to remove the seat exten-
sion first and repeat the same proce-
dure to remove the seat.
Engine Compartment
This is where the mechanical, electri-
cal and fuel/oil systems are located.
WARNING
Components inside engine com-
partment may be hot. When starting
or operating the engine, do not
touch any electrical part. Never
leave any object, rag, tool, etc., in the
engine compartment or in the bilge.