Maintenance - Worx WG168 Instructions Manual

Repeat above until you hear the lines hitting
against the line cutter.
To mANuAlly FEEd THE liNE
(See Fig. i1)
AlwAyS REmovE THE BATTERy
PACk BEFoRE AdJuSTiNG THE
TRimmER HEAd PoSiTioN.
If required, line can be feed out manually
To operate, press and release manual line feed
button (16), while gently pulling out the line
until it is long enough to reach the line cutter.
If the line extends past the line cutter, too
much line has been fed out.
If too much line is fed out, remove the spool
cap and turn spool counter-clockwise until the
line is at the desired length.
To REmovE THE CAP (See Fig. i2)
• Press and hold the two latches (12).
• Pull cap away from the spool holder
• When refitting the spool cap, keep all areas
of the cap and spool holder clean.
• Replace the cap, pressing firmly down
towards the spool holder to ensure cap is fully
12 12
located into position.
• Check that the cap is correctly fitted by trying
to remove it without depressing the two
latches.
REPlACE THE TRimmER liNE ANd
SPool (See Fig. J).
AlwAyS REmovE THE BATTERy
PACk BEFoRE AdJuSTiNG THE
TRimmER HEAd PoSiTioN.
• Remove Spool Cap Cover.
• For your convenience it is recommended you
buy replacement spools with the trimmer line
preinstalled.
• Remove the old Spool from Spool Holder.
Clear any broken line or cutting debris from
the spool area.
• Pull the line from the new replacement Spool
through the eyelet of the Spool Holder.
• Place new Spool into the holder with the cut
out areas of the Spool facing inward or down.
When installed into the Spool Holder, the
smooth side of the Spool should be visible.
• Release line from cleat on the Spool.
• Refit the Spool Cap Cover.
2-in-1 Grass Trimmer/Edger
To mANuAlly wiNd liNE
(See Fig. k1-k4)
Take approximately 20ft (6m) of line. Insert
0.8"(2mm )of line into the Spool holes and
wind line in the direction of the arrows on the
top of the Spool.
Leave approximately 4" (100mm) of line
unwound and place into the cleat.
Ensure that the line is neatly coiled on
the Spool. Failure to do so will impair the
efficiency of the automatic line feed.
Then fit the Spool as described above in
"Replace the trimmer line and Spool"
sTorING YoUr GrAss
TrIMMEr
Always remove the battery pack
from your trimmer after use.
Store in a dry place where the trimmer and
battery can be protected from damage.

MAINTENANCE

Always remove the battery pack
from your trimmer after use.
Always check the product prior to being used
for any damage.
Never operate your product if it is damaged
Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never
use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep all
working controls free of dust.
EN