Installation And Setup - Aastra 6731i Installation Manual

Installation and Setup

Installation and Setup
The 6731i IP Phone can be setup to share a network connection with another network device. Power can be provided by
the power adapter (sold separately), or by an 802.3af compliant network power source, or with a PoE inline power injec-
tor (optional accessory). If your System Administrator has already setup your phone, please refer to the Aastra Model
6731i IP Phone User Guide for call handling information or contact your System Administrator.
Direct or Shared Network Connection
The phone can be set up as a direct network connection to the Ethernet wall jack or as a shared network connection as a
pass-through if connecting the phone to a computer or another network device.
Direct Network Connection
Located at the top of the phone are two fully switched 10/100 BaseT Ethernet cable ports. The port marked with LAN is
used to connect the phone to the network, as well as provide power to your phone (if required). See
Network and to Power" on page 8
Network Jack
(if Inline power provided,
do not install the power adapter)
Shared Network Connection
To connect a network device (such as a computer) to the phone, connect an Ethernet cable into the network port on the
top of the phone marked with PC. Plug the other end of the Ethernet cable into the network jack on the network device
for which you are sharing the network connection.
Notes:
The PC jack on the 6731i IP Phone does not supply inline power onto other network devices. All Ethernet cables used
must be minimum category 5/5e straight-through cables, such as the cable provided with your phone.
7
for more information.
Power Adapter
Connection
Ethernet
Cables
Other Network Devices
To Other
Network Device
To Network
Power
Adapter
"Connecting to the
41-001266-06 REV02 – 04.2012