Aastra 6731i Installation Manual page 16

Hide thumbs Also See for 6731i:

Table of Contents

Install on the Wall

The 6731i IP phone has two pre-drilled wall mounting holes on the back of the phone.

Using the provided wall mount drilling template, locate and mark the position for the mounting screws on the wall.

Depending on the wall type, you may need to use wall anchors. Both the screws and wall anchors are included with

your phone.

Place the wall mount holes on the phone over the screw heads on the wall and pull down to lock the phone in.

Note:

You may wish to purchase a short Ethernet cable from a local supplier for a wall installation. Also, if 802.3af com-

pliant in-line power is not provided on your network, and you are installing the 6731i on a wall using a PoE in-line

power injector, you may also wish to use an equivalent flat Ethernet cable rather than the one provided.

In the handset cradle, there is a small clip that sits flush with the cradle surface. Using a small flathead screwdriver,

pull the clip up and remove it from the phone.

With the arms on the clip facing you and the flat side of the clip towards the phone, turn the clip 180 degrees and

reinsert it back into the clip cavity in the phone's cradle.

41-001266-06 REV02 – 04.2012

Wall Mount Holes

Installation and Setup

Table of Contents