Placing The Ember Material - Heat-N-Glo BAY-INS Installer's Manual

15

Placing the Ember Material

Two separate bags of ember material are shipped with
this gas fireplace:
• The bag labeled Golden Ember (GE-93) is flame
colorant material.
• The bag labeled Glowing Ember (050-721) is
standard glowing ember material.
To place the ember material:
• Remove the top trim door by lifting up and removing
from the unit. Flip down the lower trim door.
• Remove the wing nuts and glass clip at the top of
the glass door.
• Remove the glass door from the unit.
• Cover the top of the burner with a single layer of
ember material. Then sprinkle GE-93 on top of the
burner.
• Save the remaining ember materials for use during
fireplace servicing.
• Replace the glass door.
• Replace the wing nuts and glass clip.
• Hand tighten the wing nuts. DO NOT OVER-
TIGHTEN WING NUTS. HAND TIGHTEN ONLY.
• Replace top and bottom trim doors.