Step 7 Installing Trim, Logs, And Ember Material; Installing The Trim; Positioning The Logs - Heat-N-Glo BAY-INS Installer's Manual

BLK
BLK
BLK
BLK
TEMPERATURE TEMPERATURE
SENSOR SWITCH SENSOR SWITCH
FAN
Figure 9. Fan Wiring Diagram
Step 7 Installing
Trim, Logs, and
Ember Material
FAN WIRING DIAGRAM
VARIABLE SPEED CONTROL
BLK
JUNCTION BOX
BLK
BLK
WHT
BLK
GROUND
GRN
BLK
110-120 VAC
JUNCTION
BOX

Installing the Trim

Combustible materials MUST NEVER overlap onto
the front face.
WARNING
WHEN FINISHING THE FIREPLACE INSERT,
NEVER OBSTRUCT OR MODIFY THE
AIR INLET/OUTLET GRILLES ON THE
INSERT IN ANY MANNER.
Install optional surround kits as desired.

Positioning the Logs

If the gas logs have been factory installed they should
not need to be positioned.
If the logs have been packaged separately, refer to the
installation instructions that accompany the logs.
Save the log instructions with this manual.
If sooting occurs, the logs might need to be
repositioned slightly to avoid excessive flame
impingement.
NOTE: IF ANY OF THE ORIGINAL WIRE NOTE: IF ANY OF THE ORIGINAL WIRE
AS SUPPLIED WITH THE APPLIANCE AS SUPPLIED WITH THE APPLIANCE
MUST BE REPLACED, IT MUST BE MUST BE REPLACED, IT MUST BE
REPLACED WITH TYPE 105 DEGREE C REPLACED WITH TYPE 105 DEGREE C
RATED WIRE. RATED WIRE.
BLOWER RECEPTACLE
BLK
WHT
WHT
TEMPERATURE
SENSOR SWITCH
SPEED CONTROL
(RHEOSTAT)
BLOWER
14