Simplex Ethernet Clock Installation Manual page 13

Surface Mounting Procedure
1. Determine the clock mounting location.
2. Mark two points 10" (25.4 cm) apart, level and centered on the data
cable outlet.
3. Insert two flat-head fasteners suitable for the wall surface at the
marked points and tighten.
4. Withdraw the fasteners until there is a .1/16" (.16cm) gap between the
mounting surface and the back of the fastener head.
5. Insert the data cable into the jack located at the back of the Simplex
Ethernet Clock.
6. Position the keyhole slots located on the rear of the clock over the
fastener heads.
Pull the clock slightly downwards until the unit is seated.
©2007 Simplex Time Recorder Co. All rights reserved.
Page 10