Step3 Connecting To The Power Supply; Step4 Connecting The Printer To Your Computer - Canon Laser Shot LBP-1120 Getting Started Manual

Connecting to the Power
Supply
STEP3
CAUTION
Before inserting the plug, make sure that the rating indicated on the printer
matches the voltage of the AC outlet.
1
Plug the power cord into the power socket.
2
Connect the other end of the power cord to the AC outlet.
3
Turn on the printer by pressing the "I" mark. (Turn off the printer by pressing
the "O" mark.)
NOTE
If the power does not turn on even when the printer is plugged into an AC
outlet, check the following items:
• Close the front cover if open.
• Make sure that the EP-22 cartridge is installed.
• If the EP-22 cartridge is already installed, remove and reinstall it.
• To reset the printer, turn off the power using the power switch, and unplug
the power cord. Wait two seconds or more, then connect the printer to the
5
AC outlet again.
Connecting the Printer
to Your Computer
STEP4
NOTE
Do not connect/disconnect a USB cable in the following states:
• The printer driver is being installed.
• The starting period of Windows after turning on a computer.
• The printer is performing a printing action.
You can connect/disconnect a USB cable even when the computer or the
printer is turned on. However, if the cable is connected/disconnected in
the states shown above, the computer and the printer may not function
properly.
• Connect/disconnect a USB cable at least five seconds after it was
disconnected/connected. When the computer or the printer is turned on,
be sure to connect/disconnect a USB cable at least five seconds after it
was disconnected/connected. If you connect/disconnect a cable soon after
it was disconnected/connected, the printer may not function properly.
CAUTION
Do not touch the metal surface of a USB plug when connecting/
disconnecting a USB cable. It may cause electrical shock.
1
Connect the square shape plug of the USB cable to the USB interface at the
rear of the printer.