Husqvarna AUTOMOWER Operator's Manual page 8

1. INTRODUCTION AND SAFETY
Transport
The original packaging should be used when
transporting Automower over long distances.
To safely move from or within the working area:
1. Press the STOP button to stop the mower.
If the stop protection, (see page 59) used to
prevent theft, has been activated, open the solar
cell panel using the cut-out on the back edge of
the panel and enter the first number of the PIN
code.
You select the four digit PIN code when you start
the mower for the first time, see page 31.
2. Move the main switch to the OFF position if you
intend to carry the mower.
3. Carry the mower by the handle at the rear under
the mower. Carry the mower with the blade disc
away from the body.
Maintenance
WARNING
When the mower is turned upside
down the main switch must always
be set to the OFF position.
The main switch should be set to the
OFF position during all work on the
mower's underframe, such as
cleaning or replacing the blades.
• Inspect Automower each week and replace any
damaged or worn parts.
Check especially that the blades and blade disc
are not damaged. Replace all blades and screws
at the same time if necessary so that the rotating
parts are balanced, see 8. Maintenance on
page 68.
3012-814
3012-395
3012-409
English - 9