Husqvarna AUTOMOWER Operator's Manual page 24

Passages when searching for the charging station
The distance between the boundary wires in a
passage must be at least 10 ft in order for Automower
to follow the boundary wire through the passage
without the need of changing the mower's default
settings. When the distance is less than 10 ft, there
are two options available that permit Automower to
run through the passage.
1. Install a guide wire.
When the distance between the boundary wires
is less than 10 ft, it is recommended to install a
guide wire through the passage. For more
information about the guide wire, see 3.8
Installation of the guide wire on page 32.
Usually the installation of the guide wire is the best
solution with narrow passages.
The narrowest passage that Automower can run
through with the help of a guide wire is 2 ft
between the boundary wires.
2. Change the Corridor width setting (3-2-3).
When the distance between the boundary wires in
a narrow passage is more than 7 ft it is possible
for Automower to run through the passage if a low
value is set for the Corridor width (3-2-3) function
(see page 54). However, a low value involves a
large risk of tracks forming along the entire
boundary wire.
The transition between a large area and a passage
should be, if possible, designed like a funnel, with
rounded corners, to make it easier for Automower to
enter the passage.
Slopes
The boundary wire can be laid across a slope that
slants less than 10 %.
3. INSTALLATION
Secondary
area
At least 10 ft
Main area
3012-684
3012-830
English - 25