Husqvarna AUTOMOWER Operator's Manual page 26

Tip!
Use the supplied measurement gauge as a guide
when you lay out the boundary wire. This helps you to
easily set the correct distance between the boundary
wire and the boundary/obstacle.
If you intend to staple down the boundary wire:
Tip!
• Mow the lawn where the wire is to be laid using
a normal lawn mower or a trimmer. It will then be
easier to lay the wire close to the ground and the
risk of the mower cutting the wire off is reduced.
• Make sure to lay the boundary wire tight to the
ground and secure the staples close together with
approximately 30" between each staple. The wire
must generally lie close to the ground, so as not to
be cut off before the grass roots have grown over it.
• Use a hammer to knock down the staples in the
ground. Exercise care when knocking in the
staples and make sure the wire is not under
strain. Avoid forming the wire in sharp bends.
If you intend to bury the boundary wire:
• Make sure to place the boundary wire at least
0.5" and a maximum of 8" into the ground.
The boundary wire must not be crossed on the path
to and from an island.
Laying the boundary wire in towards the charging
station
The boundary wire can be routed in several different
ways in towards the charging station. The best
alternative is to route the wire completely outside the
charging station, see alternative 1. The wire can also
be placed under the charging station plate as shown
in alternative 2 in the illustration. However, the wire
should not be placed outside alternative 2 because it
can then be difficult for Automower to find the
charging station.
3. INSTALLATION
1.
2.
3012-745
3012-686US
3012-671
English - 27